Assembly
Step 12:
•
Remove the door panel (2).
•
Pry open the plastic cap of the sandbox (pre-installed on the base plate (6)).
•
Fill the sandbox with sand or water, then securely close the plastic cap.
Step 13:
•
Place an LPG cylinder (not included) on the base plate (6). Connect the regulator end of the gas hose with the
LPG cylinder (not included). Do not cross-thread. Secure the LPG cylinder with the gas cylinder brackets (5) by
tightening the 3 long bolts (C).
NOTICE
18
Only use a standard 20 lb LPG cylinder.
5
6