Installation - Heath Zenith 1931 Installation Manual

INSTALLATION

Mounting the Solar Light Fixture:
For best performance, mount the solar light fixture about 6
feet (1.8 m) above the ground. Note: Ensure the fixture
and the solar panel are located close enough together
for the cord to reach.
1. Remove the two locking screws from the sides of the
battery case and remove the wall plate.
2. Use two screws and anchors to mount the wall plate
to a solid surface. Make sure there is enough verti-
cal space above the mounting plate to allow the light
fixture to be mounted.
3. Slide the rear of the battery case onto the wall mount-
ing plate. Replace the locking screws into the side of
the battery case.
Mounting the Solar Panel:
1. Use four screws and anchors to mount the solar panel
Locking Screw
Wall Plate
2. Adjust the angle of the solar panel by grasping the
2
to a solid surface. IMPORTANT: Caulk around the
base and on top of the screw heads after instal-
lation.
panel and gently rotating it up or down as needed.
Remember, the solar panel must receive as much
direct sunlight over the course of the day as possible.
Keep in mind that shadows may block the sunlight
from reaching the solar panel during the day.
206891-03