Connection Diagrams - CAME R Series Manual

and on the same plane;
- Secure the TX and ❺ ❻ boards and connect them as shown
in the diagrams , or ;
DELTA-I fi gure - On masonry wall set up the DOC-S ❷, sink-in
containers, positioning them at the same height and plane.
While, on metal posts, perforate with a hollow ø 60 ⓒ casing
bases ❸.
- Perforate ⓐ from the back, the container bases to allow cables
to pass through (use a cable gland ❾); hen secure the bases
using supplied screws and ORs ❼;
- Connect the TX and RX ❺ boards as shown in the
diagrams and then snap in onto the container bases, sliding
them along their apposite rails ⓓ;
DELTA-E / DELTA-I - Close the container base using the screw
❽ hooking in and turning the front piece ❹ from top towards
the bottom.

Connection diagrams

Figure - Connecting a pair of photocells.
- Connecting two or more pairs photocells* (maximum
Figure
4 pairs).
- For the C-NC output contacts, follow connecting/operating
directions in the supplied Came control panel manual .
*Alternatively, install the TX transmitter and RX receiver. Also,
to avoid overlapping signals with AC power supply, invert the
polarities between pairs of photocells and switch DIP Switch 1
to ON on all boards.
To switch from 12 V power (24 V being the standard), swith
Dip Switches 2 to ON .
The data and information reported in this installation manual are susceptible to change at any time and without obligation to notify users.
Decomissioning and disposal
The packaging components are made of different materials, most
of which (paper, plastic, etc.) are fi t for solid urban waste disposal
and recycling.
Always check pertinent local legislation before acting.
While, other components such as control boards and transmitter
batteries and so on, and any other hazardous materials must be
removed and handed to specialised waste disposal fi rms.
DO NOT DISPOSE OF IN THE ENVIRONMENT!
, , or
Declaration
Pursuant to Electromagnetic Compatibility Directive.
CAME Cancelli Automatici S.p.A. hereby
declares under its own liability, that the
following gate and garage door automation
products, called:
DELTA-E / DELTA-I
Comply with the essential prerequisites
and applicable provisions, set forth by the
following Directives and applicable parts of
the reference Standards:
R
EFERENCE CODE TO REQUEST COPY OF THE ORIGINAL
STAMENT OF COMPLIANCE
2004/108/CE - Electromagnetic
Compatibility Directive
2006/95/CE - Low Voltage Directive
Standards
EN 61000-6-1, EN 61000-6-2, EN
61000-6-2, EN 60335-1, EN 13241-1.
DDC E D006
: