Before Installing The Controlpro - Pentair ControlPro Series Installation Manual

Before Installing the ControlPro

PENTAIR ControlPro ™ provides all the major functions for the pool filtration management. It's a compact system, easy
to install and use.
The Interface Module is installed in an existing wiring cabinet to avoid external wiring. The control unit can be
installed in the most convenient location either near the entrance to the equipment room or directly in the house, or
both. It is possible to connect an optional second control module that will display inside the house real-time
information regarding your pool filtration.
Pentair ControlPro ™ allows you to control and program automatic backwash using the Pentair ProValve. Also, if used
with a VS variable speed pump, the Pentair ControlPro ™ system will automatically select a higher speed if required.
Once completed, the pump will return in economy mode. More time to enjoy your pool in a quiet environment.
When the temperature goes down to 1 ° C (adjustable). Pentair ControlPro ™ activates the pump to circulate the
water and prevent pipes from freezing. While other systems continuously control the pump, our intelligent antifreeze
system operates the pump only 20 minutes every 2 hours, thus resulting in energy savings for the same results. When
backwashing, Pentair ControlPro ™ closes the dosing output as a safety feature.
Variable Speed Control
Pentair ControlPro ™ control allows you to program up to 4 preset speeds and filtration times to operate the pump at
the desired speed. A "Boost" manual allows the use of a vacuum cleaner at any time. This mode uses the maximum
speed.
Double intelligent heating control
When a heat pump and a solar heating system are connected, Pentair ControlPro ™ gives priority to free and
renewable solar energy when available. When daylight decreases, Pentair ControlPro ™ restarts the heat pump to
maintain the desired water temperature.
Thermoregulation
When used with a single speed pump, Pentair ControlPro ™ automatically adjusts the filter length as a function of the
water temperature and the position of the pool cover. If the temperature is low and / or if the pool cover is closed,
the filtration will be shortened thus reducing energy consumption.
5