Backup Battery Selection (J7 And Bt1); Compactflash Configuration (J9) - Motorola PATX3070 Series Installation And Use Manual

Backup Battery Selection (J7 and BT1)

J7 is the battery backup configuration point. BT1 is the socket for the on-
board battery.
To use the on-board battery for backup, verify that a battery (Panasonic
CR2032) is installed securely in socket BT1. With a jumper installed at J7
(pins 1-2 together), the on-board battery is enabled (this is the factory
default).
To use an external battery for backup, remove the jumper from pins 1-2
and instead connect the external battery cable to J7. Pin 1 connects to the
negative side of the external battery, pin 4 to the positive side.

CompactFlash Configuration (J9)

The SanDisk CompactFlash cards, which can be used on the PATX3070,
contain an intelligent controller for management of the Flash media. The
CompactFlash implementation mimics the file structure of a hard disk
drive. These characteristics make it possible for the PATX3070 to treat the
CompactFlash card as a bootable device.
With a jumper installed across J9 pins 1-2, the CompactFlash device is in
''master'' mode. This configuration enables the PATX3070 to boot from
the CompactFlash card.
http://www.motorola.com/computer/literature
J7
−
+
1 2 3 4
BT1
−
+
Hardware Configuration
1-9
1