Cpu Cooler - Motorola PATX3070 Series Installation And Use Manual

Notes Be sure that the CompactFlash master/slave setting (jumper

CPU Cooler

A CPU cooler is installed on the Intel PGA 370 socket to keep your
microprocessor cool. A CPU cooler includes a heat sink as well as a fan
and is more efficient than a heat sink alone. See the following procedure
and illustrations for installation instructions.
1. Hold the air cooler with the shorter end metal spring clip (point "a")
2. Set the guide pin all the way to the left.
http://www.motorola.com/computer/literature
header J9) is compatible with the secondary IDE devices
installed.
If the CompactFlash card is the only device installed on the
secondary bus, set it to master mode. If an additional IDE device
is present on the bus, the CompactFlash card can be in either
master or slave mode, with the other IDE device being set the
opposite way. (If an ATAPI device is present on the bus,
however, the CompactFlash card must be in master mode and the
ATAPI device in slave mode.)
b
toward your wrist.
Hardware Installation
a
1
1-23