Table of Contents
Advertisement
OPERATING FEATURES / REALIGNMENT
3. Data Programming (PC Mode)
3-1. Preparation and Connection
TK-5400 transceiver is programmed by using a personal
computer, programming interface cable KPG-36, and pro-
gramming software KPG-78D.
The programming software can be used with an IBM-PC
or compatible machine. Figure 1 shows the setup for pro-
gramming.
3-2. Programming Interface Cable KPG-36 Description
The KPG-36 is required to interface TK-5400 to the com-
puter. It has a circuit in its D-sub 25pin connector case that
converts RS-232C logic level to TTL level.
KPG-36 is used to connect between TK-5400 universal
connector and RS-232C serial port of computer.
3-3. Programming Software KPG-78D Description
KPG-78D is the programming software for TK-5400 sup-
plied on a 3.5" floppy disk. This software runs under Win-
dows 95, 98, ME or Windows 2000 on an IBM-PC/XT, AT, or
PS2 or compatible machine.
The data can be input to or read from TK-5400 and edited
on the screen. The programmed or edited data can be
printed out. It is also possible to tune the transceiver.
We recommend that install KPG-78D for example to
harddisk first then use it.
KPG-78D instruction manual part No. : B62-1593-XX.
KPG-78D
Fig. 1
IBM-PC
KPG-36
REALIGNMENT
1. Mode
User mode
PC mode
Panel test mode
Firmware programming mode
Mode
User mode
Customer use this mode
PC mode
Communication between the radio
and PC (IBM compatible).
It requires the KPG-78D
PC programming mode
Frequency, signalling and features
write to the radio and read from
the radio.
PC test mode
Check the radio using the PC.
This feature is included in the FPU.
Panel test mode
Dealer use to check the fundamen-
(Refer to Adjustment)
tal characteristics.
Firmware programming mode
Re-write the firmware of the flash
ROM.
2. How to Enter Each Mode
Mode
User mode
Power on
PC mode
Power on begins the USER MODE.
Panel test mode
Hold down the [Side 2] key and
[PTT], turn the radio power on, and
release [PTT] first.
Firmware programming mode
Held down the [Side 2] key and
[PTT], turn the radio power on, and
release [Side 2] key first.
TK-5400
PC programming mode
PC test mode
PC tuning mode
Panel tuning mode
Function
Operation
5
Advertisement
Table of Contents
