Installing The Television Set - Philips 32DW6834/25 User Manual

Installing the television set

For a first time installation, we would recommend you use the quick start guide provided.
6
æ Positioning the television set
Place your TV on a solid, stable surface.
To avoid any dangerous situations and operating fault, do not place anything
on the TV set and leave a space of at least 5cm around the appliance.
 Connections
• Insert the aerial plug into the M socket at the rear of the set.
You can improve the picture quality by using the suppressor aerial cable supplied.
• Insert the mains plug into a wall socket (220-240 V / 50 Hz).
For the modem connection, please refer to page 25 (connection not yet required).
ê Surround loudspeakers
If your TV is fitted with FM cordless surround speake r s , please re fer to page 26.
Connect the 2 Surround loudspeakers as illustrated opposite.
The loudspeakers should be located at the rear or on either side of the
listener (always connect 2 loudspeakers).The positive wire (the one with
the black line) to the red loudspeaker connection, the negative wire to the
black loudspeaker connection.
® Remote control
• Insert the two R6-type batteries (supplied) making sure they are the right
way round.
• Press the key of the remote control to be sure it is in the TV mode.
TV
A green indicator lights-up around the
In an effo rt to help protect the env i r o n m e n t , the batteries supplied with this telev i s i o n
do not contain mercury or nickel cadmium. Please do not discard your used batteri e s
if you have access to a recycling facility (if in doubt, consult your dealer).
† Card reader
If you have a Smartcard for ONdigital channels, insert it in the slot as
indicate opposite, making sure it is the right way round (gold chip facing
you, arrow pointing to the slot).
Switching on
Ú
• Press the on/off key to switch on the television.
A green indicator comes on and the screen lights up. If the television
remains in standby mode, press the P
• The first time the TV set is switched on, it will generate the following
message;'Welcome. Press select on your remote to get started'.
Press the key in the centre of the cursor to activate.
If the message does not appear, the television is in analogue mode.
Press the key on the remote control to switch the TV from analogue
to digital mode.
The TV indicator flashes when you use the remote control.
key.
TV
key on the remote control.