Table of Contents
Advertisement
Available languages
Available languages
Manual instruction | High pressure cleaner
The use of the winding high
pressure hose device
(HPC-2400)
The winding high pressure hose
device can be moved using the
handle provided.
•
To increase the length of
the hose rotate the handle
clockwise.
•
To shorten the length of
the hose rotate the handle
counterclockwise.
Using the washer
•
We recommended that washing procedure
should be performed in two stages:
•
Dirt dissolution:
fluid into a fan shaped jet stream and wait for
a moment until the fluid begins working.
•
Dirt removal:
point jet stream.
•
While cleaning, make sure that the washer is
positioned on an even base.
•
You should not move outside the work area
limited by the length of the high pressure hose, as
you may upset the washer's balance.
•
While washing vertical surface, apply the
washing fluid upward.
Maintenance and cleaning
Before performing maintenance or tool
replacement unplug the power cord
and disconnect the device's water
supply.
Keep the body of the washer clean and free from
debris. The high pressure hose, the handgun and
the lance should also be kept clean.
Regular cleaning of the nozzle is important to the
efficient operation of the washer.
The nozzle must be cleaned at regular intervals
using the nozzle cleaner (17) provided.
(HPC-1400)
(HPC-2000)
(HPC-2400)
Should
the
machine
manufacturing and testing procedures, repair
should be carried out by authorized customer
service center for IVT power tools.
EN
introduce the washing
wash the dirt off with a
fail
despite
rigorous
Storage
•
Disconnect the high pressure hose, the handgun
and the lance, and store them carefully in a secure
dry place.
•
Always keep power tools out of the reach of
children.
•
Avoid storing the washer at a temperature below
5 °C. Frost can cause damage to the device that has
not been fully drained.
•
Make sure that the pressure washer, the handgun
and the lance have been thoroughly cleaned before
storing.
•
Carefully remove all dirt especially from the
electric motor's air vents.
Troubleshooting
The
list
below
recommendations.
Caution: Before troubleshooting switch
the device to Off position and unplug
the cable.
Motor does not start
•
It is not plugged in
•
Line voltage does not correspond to the rating
on the data plate ► Use proper line voltage.
•
The outlet is defective
•
The extension cord is damaged
faulty cable.
•
Internal overheating protection actuated
the device cool for 5 minutes
Motor shuts down
•
Line voltage does not respond to the rating on
the data plate ► Check the line rating against the
rating on the data plate.
•
Internal overheating protection actuated
the device cool for 5 minutes.
Excessive working pressure
•
Partial obstruction (clogging) of the nozzle
Clean the nozzle.
Fluctuation in pressure
•
Air getting into the water hose or pump
Switch Off the device, while holding the lever of the
pistol grip depressed and the water tap opened,
let the water flow out until continuous working
pressure is set.
•
Irregular water supply
supply meets the technical specifications of the
8
offers
troubleshooting
► Plug it in.
► Use another socket.
► Replace the
► Ensure that water
► Let
► Let
►
►
Advertisement
Table of Contents
