Table of Contents
Advertisement
Available languages
Available languages
Manual instruction | High pressure cleaner
Tool specification
model
rated power (W)
amperage by voltage 230V (Amp)
flow rate (l/min)
work pressure (bar)
max. pressure (bar)
supply temperature max. (°C)
supply pressure max. (bar)
lenght of the high pressure hose (m)
detergent tank capacity (l)
Auto stop
weight (kg)
safety class
Safety regulations for the use
This product line of high pressure cleaners is
designed for outdoor use and is intended for
cleaning surfaces as well as various objects, tools,
vehicles and boats. The device is powered by water,
which flows in under high pressure from the entry
spout ensuring highly effective cleaning.
You find in the area of specialized trade or on our
website our assortment of accessories which allows
extensive application.
With the use of appropriate accessories cleaning
solutions may be injected into the water stream, and
the device can be adapted for drain/sewer cleaning
or rust/paint removal.
Compliance with safety instructions will ensure
correct usage of the device and your safety.
Therefore, please read this manual very carefully.
When passing this device over to a third person,
these instructions must be handed out, too.
Connecting to power source
•
Voltage data indicated on the nameplate shall
con form to the power source ratings.
•
Devices of the Protection Class IP 1 shall be con-
nected only to properly grounded power sources.
•
The device must be grounded. If an extension
cord is used while operating the high pressure
device, the cross-section shall be as fol lows:
•
1.5 mm at max. Length 20 m
•
2.5 mm at max Length 50 m
•
Pursuant to safety rules the extension cord to be
used must have a ground wire connected via the
EN
HPC-1400
HPC-2000
1400
6.10
4.5
60
90
40
3
3
0.5
+
6.5
II
plug to the main circuit ground
Use of an improper extension cord may
be hazardous! The extension cord and
its connectors must be waterproof and
approved for outdoor use.
•
To ensure safety of the appliance use only original
spare parts from the manufacturer or approved by
the manufacturer.
•
If the device's cable must be replaced, use only a
power cable provided by the manufacturer.
•
Never handle the plug with wet hands. Keep
cable connectors dry, and make sure they do not
contact with water or lie on the ground.
•
Use a strain relief device with extension cords to
relieve tension.
•
To prevent damage of power or extension cords,
do not squeeze, stretch or drive over the cords.
Protect the cables against overheating, contact with
oil or objects with sharp edges.
•
To increase safety, it is recommended to use
residual current device (RCD), rated for leakage
current of no more than 30 mA. Check the condition
of such devices, prior to each use.
•
If the power or extension cord couplings are
replaced, their water-resistance and mechanics
integrity must be preserved.
•
Always protect electrical parts of the device
against water jet.
•
Disconnect the device from electrical power
supply before carrying out maintenance.
Connecting to the water supply
•
Always comply with the requirements of local
4
HPC-2400
2000
2400
8.70
10.40
5.5
90
135
60
3
5
1.0
+
9.5
II
6.0
120
180
60
3
6
1.1
+
20
I
Advertisement
Table of Contents
