Initial Operation; Switching On/Off - IVT HPC-1400 Operating/Safety Instructions Manual

Manual instruction | High pressure cleaner
4. (HPC-1400) connect the handgun (11) to the gun
connector (9).
4. (HPC-2000; HPC-2400)
Fasten the end of the high
pressure hose (14) to the
handgun (11), use a
17mm spanner (not
supplied) to tighten the screw.
5. (HPC-1400) Connect the lance (10) to the gun
connector (9).
5. (HPC-2000; HPC-2400) Connect the lance (10) to
the handgun (11).
HPC-2000
HPC-2400
6. Turn the water supply on, making sure that the
tap is fully open.
7. Plug the mains power cable into electricity
8. Release the lock-off button (12)
9. Press the On/Off switch (2) to the On position
marked "I".
10. (HPC-2400) Pull the high pressure hose (14) out
of winding device (15) until appropriate length.
11. The pressure washer is now ready for use

Initial operation

• Make sure that the voltage data of electrical
power supply are displayed on the washer's data
plate.
• Make sure that the washer is connected to the
water supply system with the correct parameters
(the maximum pressure and temperature cannot
exceed the values specified in the technical data
table).

Switching On/Off

Switching the washer On
WARNING! Before using the pressure
washer make sure that there are no
other people or domestic animals in the
work area.
To switch the pressure washer On, proceed as
follows:
1. Make sure that the pressure washer has been
EN
correctly assembled and prepared for use.
2. Press the On/Off switch to On position marked I.
3. Adjust the spray.
4. Release the lock-off button (12) and point the
nozzle at the area to be washed.
5. Squeeze the trigger.
6. Proceed with the wash.
CAUTION! Some painted or treated surfaces may
be susceptible to damage from high pressure jet
washer. When cleaning vehicles for example, always
check with the manufacturer whether the surfaces
to be cleaned are suitable for pressure washing or
whether any restrictions apply.
Some useful general precautions are:
• Never position the nozzle at the distance nearer
than 30 cm to the area being cleaned (If in doubt
test on a small unseen area first).
• Never use pressure washer on areas with loose
paint or poorly secured trims/fittings.
• Always keep the water jet moving over the
surface. Do not leave the jet in the same position for
a prolonged period as this could cause damage to
the surface.
• To be sure, always check with the suppliers of
the item to be cleaned that surfaces are suitable for
pressure jet washing.
Switching the washer Off after use
When you have finished using the pressure washer,
follow the procedure shown below to switch off and
disconnect the unit:
1. Press the On/Off switch to the Off position
marked 0.
2. Turn off the water supply at the tap.
3. Discharge water in the pump and the hose by
squeezing the trigger for a few seconds, or until no
water comes out.
4. Lock the handgun in the Off position through
the lock-off button (12).
5. Disconnect from the mains power supply.
Operating instruction
Adjusting the spray
The nozzle is adjustable to allow you to adjust the
spray from a tight jet of water to a wide spray.
To adjust the nozzle, proceed as follows:
1. Hold the shaft of the
lance in one hand.
2. Twist the nozzle
with the other hand
3. The tight jet should
be used to clean small
6