Engine/Blower/Blade Assembly Installation - Peco 05721201 Operator's Manual

2-7 Engine/Blower/Blade Assembly
Installation
Place the engine/blower/blade assembly on top of the
engine mount arm assembly as shown in Figure 2-7a.
Secure the assembly using (4) 5/16"-18 x 1-1/2" HHCS
P#(K1157) and (4) 5/16"-18 nylon flange lock nuts
P#(K2516) as shown in Figure 2-7b. Adjust the position
of the outer engine mount tube so that the blower
housing has at least 1" of clearance from the rear tire.
Tighten the u-bolts on the outer engine mount tube at
this time.
Figure 2-7a
Engine/Blower
Blade Assembly
Outer Engine
Mount Tube
Engine Mount
Arm Assembly
Figure 2-7b
(4) 5/16"-18 x 1-1/2"
Hex Bolts
(4) 5/16"-18 Locknuts
9