Table of Contents
Advertisement
2-22 Throttle Cable Installation
To install the throttle cable kit P#(A0060) to the box
assembly, align the large end of the slot in the throttle
base plate (Figure 2-22a) with the rivets located on the
front of the box assembly frame (Figure 2-22b). Place
the throttle base plate over the rivets, Slide the throttle
cable kit to the right, moving the smaller end of the slot
over the rivets. When positioned correctly, the throttle
spring plate will snap into place (Figure 2-22c).
To remove the throttle cable kit, lift the throttle spring
plate and slide the throttle kit to the left.
Throttle Base Plate
Throttle Spring
Plate
Figure 2-22b
Figure 2-22c
Figure 2-22a
Throttle
Box Assembly
Rivet
Box Assembly
Throttle Cable Kit
Properly Positioned
Figure 2-22d
Throttle Cable
To fasten the throttle cable end to the engine, place the
throttle control lever into the "stop" position. Rotate the
engine throttle lever to the "stop" position. Thread the
wire end of the throttle cable into the engine throttle lever
eyelet and tighten the screw. Fasten the throttle cable
sleeve to the clamp on the engine throttle. Rotate the
throttle control lever into the "fast" position to check for
proper installation.
Note: Cable sleeve may need to be cut depending on
the engine type. Once throttle cable is attached, pull the
box handle to dump the box and be sure the cable does
not alter the movement of the box.
Throttle Cable Clamp
Figure 2-22e
17
Engine Throttle Lever
Advertisement
Table of Contents
