Lift Handle Installation - Peco 05721201 Operator's Manual

2-10 Lift Handle Installation

NOTE: Before continuing the lift handle installation,
have someone assist you in turning the grass container
upside down. Insert (1) 3/8"-16 x 2" HHCS P#(K1208)
into the lift handle P#(A0273), and secure with (1) 3/8"-
16 flange nut P#(K1215). Thread the flange nut onto the
bolt upside down, as shown in Figure 2-10a.
Insert (1) 3/8"-16 x 2"
HHCS Into The Lift Handle
Slide the lift handle through the slot on the handle mount
bracket. Insert the lift handle into the box frame as
shown in Figure 2-10b, and secure using (1) 3/8"-16
flange nut P#(K1215) on the inside of the container as
shown in Figure 2-10c.
Slide Lift Handle Through
Handle Mount Bracket And
Fasten To Box Frame
Use (1) 3/8"-16 Flange Nut
On The Inside Of The
Figure 2-10a
Secure With
(1) 3/8"-16 Flange Nut
Figure 2-10b
Figure 2-10c
Grass Container
Fasten the ball joint P#(K1442) to the end of the latch
rod P#(A0620). Tighten the ball joint to approximately
half way down the threads on the latch rod. Attach the
ball joint to the latch hook as shown in Figure 2-10d,
using (1) 5/16"-24 hex nut P#(K1444) and (1) 5/16" lock
washer P#(K0043).
Latch Hook
Ball Joint
Figure 2-10d
Attach the other end of the latch rod to the lift handle, as
shown in Figure 2-10e. Attach on end of the spring
P#(J0176) to the lift handle and the other end of the
spring to the handle mount bracket as shown in Figure
2-10f. Adjust the ball joint up or down on the latch rod
threads until the latch hook closes completely. After
adjusting the latch hook, secure the latch rod to the lift
handle using (1) cotter pin P#(K0094).
Attach Latch Rod
To Lift handle
Attach Spring To
Lift Handle And To
Handle Mount Bracket
11
(1) 5/16"-24 Hex Nut
(1) 5/16" Lock Washer
Latch Rod
Figure 2-10e
Secure With
(1) Cotter Pin
Figure 2-10f