Chapter 4: Boot CLI fundamentals
The Boot command line interface (CLI) is a text-based interface that provides commands for configuring
the gateway boot process. You can access the Boot CLI only through a direct connection to the console
port and only during the boot process. To access the Boot CLI, during the boot process press any key
until the boot prompt appears.
This section contains information about the basic Boot CLI commands with the Advanced Gateway
2330.
You can specify to boot the gateway from any of the following locations: TFTP, FTP, CF0, or CF1. CF0
is the main internal Compact Flash memory where the system image and configuration files are stored.
CF1 is the external Compact Flash slot.
Boot CLI command list
The following table contains descriptions of the Boot CLI commands.
Table 6: Boot CLI command list
?
@
p
c
g <adrs>
d adrs[,n]
m <adrs>
f adrs, nbytes,
value
t adrs, adrs,
nbytes
e
v
n netif
available boot devices are: "tftp","ftp","cf0","cf1".
Using the Command Line Interface
print this list
boot (load and go)
print boot parameters
change boot parameters
go to address
display memory
modify memory
fill memory
copy memory
print fatal exception
print boot logo with version
print network interface device address
August 2013
19