Table of Contents
Advertisement
Step 3: Connecting and configuring your TV
Configuration A
Make sure DHCP/Auto IP (automatic network
addressing) is enabled on your router and your
PCs.
On most of the recently purchased PCs and
routers, automatic network addressing is
already enabled.
You can check this on your PC with the Network
Utility on the supplied
If DHCP/Auto IP is not enabled, see Annex 4, p. 14
to enable DHCP/Auto IP on your PC.
For enabling DHCP on your router, see the user
manual of your router.
Connecting your TV
&
Push one end of an Ethernet cable (
) into the
cable
NETWORK
bottom of the TV.
Straight cable
Push the other end into a free Ethernet
é
connector on your router.
"
Go to 'Viewing multimedia content' on p. 6 to
test your connection.
CD.
a straight
connector at the
Network conn.2 pc+TV.02.ep
Configuration B
Make sure DHCP/Auto IP (automatic network
addressing) is enabled on your PC.
On most of the recently purchased PCs,
automatic network addressing is already
enabled.
You can check this on your PC with the Network
Utility on the supplied
If DHCP/Auto IP is not enabled, see Annex 4, p. 14
to enable DHCP/Auto IP on your PC.
Connecting your TV
&
Push one end of a crossed Ethernet cable (
) into the
crossed cable
at the bottom of the TV.
Warning !
Crossed cable
Push the other end into the free network
é
connector on your PC.
"
Go to 'Viewing multimedia content' on p. 6 to
test your connection.
s
CD.
a
connector
NETWORK
5
Advertisement
Table of Contents
