Using The Hdmi Settings Feature - Toshiba Regza 40RF350U Owner's Manual

To set the CE-Link Setup:
Press Y and open the Setup menu.
1
Highlight CE-Link Setup and press T.
2
Setup
Installation
CE-Link Setup
Sleep Timer
HDMI Settings
PC Settings
Blue LED Illumination
Power-On Mode Power-Saving
3
Press B or b to highlight Enable CE-Link.
CE-Link Setup
Enable CE-Link
TV Auto Input Switch
TV Auto Power
Device Auto Standby
Speaker Preference
Reset
4
Press C or c to select On.
Note: If you set Enable CE-Link to Off, the all other items
will be grayed out.
5
Press B or b to highlight the CE-Link setup item you
want to use, and press C or c to select On/Off or the
desired speakers mode.
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver (See
•
details on the previous page.)
CE-Link Setup
Enable CE-Link
TV Auto Input Switch
TV Auto Power
Device Auto Standby
Speaker Preference
Reset
To save the new settings, highlight Done and press T.
6
To revert to the factory defaults, highlight Reset and
press T.
68
Chapter 6: Using the TV's features
High
On
On
Off
On
TV Speakers
Done
On
On
Off
On
TV Speakers
Done

Using the HDMI settings feature

This menu consists of the 2 items shown below (new HDMI
capabilities) and will be grayed out on non-HDMI inputs.
Some HDMI legacy sources may not work properly with your
HDMI TV. If you experience any problems, please unplug
your HDMI cable first and then try setting the following
options (Lip-Sync Latency and xvYCC) to Off. Adjusting
these settings should allow your HDMI legacy source to
operate properly with your TV.
Lip-Sync Latency: On
•
This option activates an audio/video display timing
adjustment function that allows HDMI source devices to
accurately perform synchronization automatically.
xvYCC: On
•
This feature expands the color range of HDMI signals,
allowing input of wider color signals from HDMI sources.
The HDMI features require proper HDMI source devices. If
your HDMI source device does not support these features,
activating them on the TV will not have any effect.
Note: If your HDMI connection is capable of 1080p and/or your
TV is capable of refresh rates greater than 60Hz, you will need
a Category 2 cable. A conventional HDMI/DVI cable may not
work properly with these settings.
To set the HDMI Settings:
1
Select the appropriate HDMI input (HDMI 1, HDMI 2, or
HDMI 3).
Press Y and open the Setup menu.
2
Highlight HDMI Settings and press T.
3
4
Press B or b to highlight the item you want to set.
HDMI Settings
Lip-Sync Latency
xvYCC
Please unplug your HDMI cable first!
Once you have changed On/Off settings, please press
Done and wait for changes completed message.
Warning: DO NOT TURN OFF OR UNPLUG THE TV UNTIL
COMPLETED MESSAGE IS DISPLAYED!!
Reset
5
Press C or c to select On or Off .
To save the new settings, highlight Done and press T.
6
To revert to the factory defaults, highlight Reset and
press T.
HDMI 1
On
On
Done