Maintenance And Storage - Stiga Park Series Instruction Manual

(Translation of the Original Instructions)
Do not change the engine governor set-
tings or overspeed the engine
Do not touch engine components which
get hot during use Burns hazard
Disengage the cutter blade or the PTO,
set the engine to the idle position, stop
the engine and remove the key (make
sure that all moving parts have come to
a complete stop):
a whenever you leave the machine
unattended or leave the driver'r seat.
b before removing the jamming cause
or unclogging the collector channel;
c before checking, cleaning or working
on machine;
d after striking a foreign object. Inspect
the machine for damage and make
repairs before restarting and opera-
ting the machine;
Disengage the cutter blade or the PTO
and stop the engine (make sure that all
moving parts have come to a complete
stop):
a Before refuelling;
b Every time you remove the grass col-
lector sack or put it back on;
c adjusting the cutting height, assuming
this operation cannot be done from
the driver's seat.
Disengage the cutting blade or the PTO
during transport or whenever the ma-
chine is not being used
Reduce the throttle setting before stop-
ping the engine. turn the fuel off at the
conclusion of mowing, following the in-
structions in the manual
Take care with multiple blade cutting
decks as one rotating blade may cause
other blades to rotate
WARNING - In the event of failures or
accidents when working with the ma-
chine, stop the engine immediately
and move the machine away to avoid
causing further damage; in the event of
accidents with injuries to operators or
third parties, take the first aid measures
which are most appropriate to deal with
the situation and contact a health care
facility for the necessary treatment Ca-
ENGLISH
refully remove any debris which could
cause damage or injury to persons or
animals if ignored
CAUTION! The noise and vibration le-
vels shown in these instructions are
the maximum levels for use of the ma-
chine The use of an unbalanced cutting
element, the excessive speed of move-
ment, or the absence of maintenance
have a significant influence on noise
emissions and vibrations Consequen-
tly, it is necessary to take preventive
steps to eliminate possible damage
due to high levels of noise and stress
from vibration Maintain the machine
well, wear ear protection devices, and
take breaks while working
3 4

MAINTENANCE AND STORAGE

CAUTION! - Before cleaning or doing
maintenance work, take out the ignition
key and read the relevant instructions
Wear adequate clothing and work glo-
ves whenever your hands are at risk
CAUTION! - Never use the machine with
worn or damaged parts Faulty or worn-
out parts must always be replaced and
never repaired Only use original spa-
re parts: The use or non-original and/
or incorrectly fitted parts will compro-
mise the safety of the machine, may
cause accidents or personal injuries
for which the Manufacturer is under no
circumstance liable or responsible
Any regulations and maintenance ope-
rations not described herein must be
carried out by your Dealer or Authori-
zed Service Centre, which have the ne-
cessary knowledge and equipment to
ensure that the work is carried out cor-
rectly, maintaining the correct degree of
safety and the original operating condi-
tions of the machine Any adjustments
or maintenance operations carried out
by people not having the necessary
knowledge will nullify the warranty and
exonerate the manufacturer from all lia-
bility
• After each use of the machine, remove the key
and check for any damage.
EN
9