Table of Contents
Advertisement
Setting the HDMI™ audio mode
To select the HDMI audio mode:
1. Press MENU and open the Setup menu.
2. Highlight HDMI Audio and press •.
3. Press z y to select the HDMI audio mode (Auto, Digital,
or Analog) and press ENTER. (Auto is the recommended
mode). See "Connecting an HDMI or a DVI device to the
HDMI input" on page 19.
Setup
Installation
Auto
Sleep Timer
Digital
On/Off Timer
Analog
PC Settings
PC Audio
No
HDMI Audio
Auto
Gray Level
2
Navigate
Select
RTN
Back
#01E_038-041_27HL95
39
Black
(E) 27HL95 *Web 213 : 276
Chapter 6: Setting up your TV
EXIT
Exit
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Setting the time and date
Note: If you already set up the TV Guide On Screen
time and date were set automatically and you can skip this step.
To set the time and date:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
3. Open the Time And Date menu, highlight Start Setup, and
press ENTER.
Time And Date
Start Setup
Navigate
Select
RTN
Back
EXIT
Exit
If you have not set up the TV Guide On Screen
the following screen will appear. To set the time, highlight
TV Guide On Screen
®
and press ENTER. The TV Guide
®
On Screen
setup sequence will start, and the time and date
will be set automatically.
Time And Date
Your TV Guide On Screen system can provide accurate
time and date information.
It is recommended you set up TV Guide On Screen
first and use it to obtain the time and date.
Manual
TV Guide On Screen
Cancel
If you have already set up the TV Guide On Screen
system, or if you have not set up the time, the time and
date setting screen will appear, set the time and date
manually.
Time And Date
Date (MM/DD/YY)
0 6 3 0 / 0 5
/
1 1 1 1 AM
:
Time (HH:MM)
Cancel
Done
Note:
• If you highlight TV Guide On Screen
date through the TV Guide On Screen
outage occurs, the time and date will be updated automatically
when the power is restored.
• If you highlight Manual (above) to set the time and date manually
and a power outage occurs, you will lose the time and date settings
when the power is restored.
• If you manually set the time and date and then perform TV Guide
®
On Screen
setup, the manual time and date settings will be
overridden by the TV Guide On Screen
05.9.12, 15:38
®
system, the
®
system,
®
®
(above) to set the time and
®
system and a power
®
settings.
39
Advertisement
Table of Contents
