Table of Contents
Advertisement
Adjusting the audio
Using the SRS WOW™ surround sound
feature
WOW™ is a special combination of SRS Labs audio
technologies (SRS 3D, FOCUS, and TruBass) that creates a
thrilling surround sound experience with deep, rich bass from
stereo sound sources. Your TV's audio will sound fuller, richer,
and wider.
To adjust the WOW™ settings:
1. Put the TV in STEREO mode (see "Selecting stereo/SAP
broadcasts" on page 70).
2. Press MENU and open the Audio menu.
3. Highlight Advanced Audio Settings and press ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
4. Press zy to highlight the WOW feature you want to
adjust, and then press x • to adjust the item.
Advanced Audio Settings
WOW: SRS 3D
WOW: FOCUS
WOW: TruBass
Reset
• WOW: SRS 3D — To turn the surround sound effect On
or Off.
Note: If the broadcast is monaural, the 3D effect does not
work.
• WOW: FOCUS — To turn the vocal emphasis effect On
or Off.
• WOW: TruBass — To select the desired bass expansion
level (High, Low, or Off ).
5. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
72
#01E_065-072_27HL95
72
Black
(E) 27HL95 *Web 213 : 276
Chapter 8: Using the TV's features
(continued)
Off
Off
Low
Done
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Selecting the optical audio output
format
Use this feature to select the optical audio output format when
you connect a Dolby Digital decoder or other digital audio
system to the Optical Audio Out terminal on the TV (see
"Connecting a digital audio system" on page 20).
To select the optical audio output format:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
3. Press z to highlight the Optical Output Format field, and
then press x • to select either Dolby Digital or PCM,
depending on your device.
Audio Setup
MTS
Stereo
Language
English
Optical Output Format
Dolby Digital
Reset
Done
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
05.9.12, 15:46
Advertisement
Table of Contents
