Delta DJ-20 Series Instruction Manual page 15

INFEED TABLE
ADJUSTMENTS
To raise or lower the infeed table (see Fig. 4A), loosen
table lock handle (A) Fig. 19, and move the table raising
and lowering hand lever (B) up or down until the table is
at the desired position and tighten table lock handle (A).
NOTE: The table lock handle (A) can be repositioned by
pulling out the handle and repositioning it on the
serrated nut located underneath the handle.
The depth of cut of the infeed table (position of table in
relationship with the cutting circle) can be read with the
pointer and scale (G) Fig. 19.
INFEED TABLE
POSITIVE STOPS
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
Positive stops are provided to limit the height of the
infeed table. The positive stops can be set by loosening
lock nuts (C) and (D) Fig. 20, and turning the two
adjusting screws (E) and (F). We recommend that the
height of the infeed table be adjusted so that the table,
at its highest point, will be 1/2mm (.020" ) below the
highest point of the knives. This is an important feature
of your jointer which enables you to rapidly position the
infeed table for a finish or final cut.
OUTFEED TABLE
ADJUSTMENTS
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
The outfeed table must be exactly level with the knives
when the knives are at their highest point of revolution.
To move the outfeed table, loosen table lock handle (A)
Fig. 21, and move the table raising and lowering hand
lever (B) up or down until the table is level with the
knives. It may be necessary to loosen the two locknuts
(C) and (D) Fig. 22, and the two adjusting screws (E) and
(F) when moving the table up or down. When the outfeed
table is exactly level with the knives at their highest point
of revolution, tighten table lock handle (A) Fig. 21, and
turn adjusting screw (E) Fig. 22, until it bottoms. Then
tighten lock nut (C). Screw (F) is also a positive stop for
the lower limit of the outfeed table. We suggest that this
stop also be tightened with locknut (D), when the
outfeed table is set level with the knives. This will
prevent the outfeed table from accidentally being
lowered.
A
F
D
B
E
C
D
15
G
B
Fig. 19
E
C
Fig. 20
A
Fig. 21
F
Fig. 22