Mount The Sensor Cartridge - Honeywell Midas-M User Manual

Mount The Sensor Cartridge

The Midas-M Sensor Cartridge enables the detection of a wide range of asphyxiant, toxic,
flammable, pyrophoric, corrosive, and oxidizer (including Oxygen) gases. The plug & play Sensor
Cartridge is located inside the detector's chassis.
NOTE
The Midas-M sensor cartridge is supplied separately.
Before use, verify the part number and type of sensor cartridge is correct for your
application.
1. Turn the power off.
2. Open the door and remove the BiAS battery module and the two plug caps from the sensor
cartridge.
3. Align the Sensor cartridge pins with the socket in the sensor cartridge chamber and then
push the sensor cartridge gently until fully seated.
4. Close the door.
5. a. Press the 'O' button to clear the "Detect New Cartridge " message.
b. Confirm that the green LED is flashing, and that the yellow and red LEDs are off.
c. Confirm the display shows a concentration of zero as appropriate.
Midas-M 28 User Manual