Address Assignment - Siemens 5WG1 201-2DBx3 Series Technical Product Information

Gamma instabus
Technical product information
June 2014
Gamma arina touch sensor
Unmounting
Remove the front housing (F4)
− Remove the front housing (F4) of the touch sensor
apart from the back housing (behind the front cover
and invisible) with a screw driver, with the back hous-
ing still on the mounting frame (F1)
− Pull off the KNX connector manually from the front
housing
Figure 7: Remove the front housing
F1 Mounting frame
F4 Front housing
I1 Hole for screwdriver
Figure 8: Remove the KNX connector
F1 Mounting frame
F3 Back housing
F4 Front housing
H2 KNX connector
Technical product information
Update: http://www.siemens.com/gamma
2.16.1.13/8
single
double
quadruple
Remove the back housing (F3)
− Insert screwdriver to the holes (J1), and press as
showed in Figure 9.
− Move the back housing out of the mounting frame (F1).
− Pull the KNX connector (H2) out from the back housing.
F1
F3
H2
J1

Address assignment

− Press the programming button (F5) on the device to
initiate the assignment of the physical address to the
device (figure 1).
− The programming LED (E4) turns on to indicate the
programming mode. Upon receiving the physical ad-
dress the device automatically returns to normal oper-
ating mode and the LED turns off. The programming
LED is not invisible when turns off.
Subject to change without further notice
Figure 9: Remove the back housing
Mounting frame
Back housing
KNX connector
Hole for screwdriver
UP 20x, UP 28x/3 and UP 28x/5
Siemens Building Technologies