Shindaiwa HomePro 22C Owner's/Operator's Manual page 9

Assembly
Install the Cutting Attachment Shield
Socket-head
Cap Screws
Bracket
Shim
Cutting Attachment
Nut
Shield Mounting Plate
Figure 12
1. Insert the cutting attachment shield
between the outer tube and the
cutting attachment shield mounting
plate. See Figure 12.
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
2. Fit the two shims and the bracket
over the outer tube and loosely install
the four socket-head cap screws. See
Figure 12.
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
To Change Position of Line Cutter.
The line cutter can be positioned in
2 positions to obtain different line length
for cutting.
1. Remove the 2 hex screws with a 4mm
hex wrench. See Figure 12A.
2. Rotate line cutter. See Figure 12A.
3. Reinstall the two hex screws and
tighten them securely.
Outer Tube
Shim
Cutting Attachment
Shield
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
Bracket
head cap screws.
WARNING!
NEVER operate the unit without
the cutting attachment shield in-
stalled and tightly secured!
WARNING!
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
Be careful to not lose the 2 nuts in the
cutting attachment shield, they are not
captured.
Sub-Shield.
(when trimmer head is in use)
1. Attach the shield extension to the
Line Cutter
Hex
Screws
Figure 12A
NOTE:
cutting attachment shield.
WARNING!
NEVER use this machine without
sub-shield when using a trimmer
head.
Cutting Attachment Shield
Hook
Receiver
Sub-shield
CAUTION!
Make sure the sub-guard is com-
pletely hooked at the hook receiver.
Hook
9