Mira Bijou Installation & User Manual page 9

6. Reversed Inlet Supplies Only:
a) Using a suitable tool, carefully remove the
plug cap from the centre of the sealing
plug to reveal keyway.
b) remove the sealing plug using the 'o' key
(supplied) or a 12 mm hexagonal key.
c) remove the outlet nipple using the 'o' key
(supplied) or a 12 mm hexagonal key.
d) Refit the sealing plug and outlet nipple in
the opposite outlets and tighten.
Note! make sure that the 'o' seals are
correctly fitted.
e) remove the grubscrew using a 3 mm
hexagonal key (not supplied) and fit in
the opposite side of the mixer body.
f) rotate the mixer 180°.
g) the control knob will have to be realigned,
i.e. removed and turned through 180°, this
can be completed after commissioning.
Plug cap
sealing Plug
'o' seal
Grubscrew
7. remove the backplate from the mixer by
8. secure the backplate to the wall using the
9. For Rear Entry Supplies Only:
outlet nipple
10. Caution! It is essential at this point
9
loosening the grubscrew with a 2.5 mm
hexagonal key (supplied).
screws (supplied).
a) Fit the concealing plates over the inlet
pipes.
Note! apply silicone sealant to the back
face of the flange.
apply silicone sealant
that the supply pipework is thoroughly
flushed through before connection to the
mixer. Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
Backplate
screw
concealing Plate