Toshiba B-SX8T SERIES Owner's Manual page 40

2. PRINTER SETUP
2.8.1 Parameter Setting
(Cont.)
NOTES:
1. The ribbon saving function is
activated when there is a 20-mm
or more non-print area in the
media feed direction.
2. Ribbon saving is enabled up to 4
areas per media.
3. To use the ribbon saving function
for more than one area in a
label/tag, there should be at least
an 8-mm print area between non-
print areas where the ribbon
saving is performed.
(11) Ribbon Save Function Selection
This parameter is to choose whether to activate the Ribbon Saving
function or not.
This function enables reducing the ribbon loss caused by taking up
unused ribbon during non-print areas.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
RBN SAVE ON (TAG)
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the ribbon save function, press the [PAUSE] key.
(12) Control Code Selection
This parameter is to choose a Control Code.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
CODE AUTO
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
E2-26
ENGLISH VERSION EO1-33057
2.8 Setting an Operating Environment
RBN SAVE OFF
Not activated
RBN SAVE ON (LBL)
Activated (When the head lever is set to
position 1)
RBN SAVE ON (TAG)
Activated (When the head lever is set to
position 2.)
CODE AUTO
CODE ESC,LF,NUL
CODE{|}
CODE MANUAL
Automatic selection
Manual selection
Manual selection
Control codes should
be specified.