Table of Contents
Advertisement
Removing a copper pass-thru module
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the
following label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Complete the following steps to remove a copper pass-thru module:
1. If the BladeCenter unit is an IBM Eserver BladeCenter Type 8677 unit,
remove the acoustic-attenuation module, if installed, from the rear of the
unit (see step 3 on page 18 to locate the attenuation module).
2. Disconnect any cables from the selected copper pass-thru module.
20
IBM BladeCenter Copper Pass-thru Module: Installation Guide
Advertisement
Table of Contents
