Table of Contents
Advertisement
The following illustration shows how to install a copper pass-thru module in
an I/O module bay in the rear of an IBM Eserver BladeCenter T Type 8720 or
8730 or similar BladeCenter unit.
Filler
module
Filler
module
Complete the following steps to install a copper pass-thru module:
1. Make sure that you are using the latest versions of device drivers,
firmware, and BIOS code for your blade server and management module.
Go to the IBM Support Web site, http://www.ibm.com/pc/support/ for
the latest information about upgrading the device drivers, firmware, and
BIOS code for BladeCenter components. The latest instructions are in the
documentation that come with the updates.
2. Review the information in "Safety" on page v, "Installation guidelines" on
page 11, and "Handling static-sensitive devices" on page 11.
Ethernet
switch
module
Release
latch
(open)
Copper
pass-thru
Release
module
latch
(open)
Chapter 2. Installing and removing a copper pass-thru module
17
Advertisement
Table of Contents
