Updating Failure; Fw Update Tool Messages; Fw Update Tool Messages: Information - Ricoh M156 Service Manual

Updating the Firmware

5.3.4 UPDATING FAILURE

If the firmware update is not successful, the update process is suspended and an error message
should appear on the FW Update Tool screen. If this happens, DO NOT turn off the machine; you
must execute the update procedure again (unless the error message "Downloaded file is broken!
Do NOT use print, scan, fax and copy function at the same time." is displayed).
If power is turned off accidentally during a firmware update, the firmware will not be correctly
updated, and the machine may not start up normally. If the machine does not start up normally, the
main firmware will need to be updated again.
When the machine does not start up normally, in most cases, the panel display will indicate one of
the following two conditions:

When attempting to restart the machine, the LCD panel display indicates "Initializing"
indefinitely.
In this case, the main firmware update has failed. The main firmware must be updated again.

5.3.5 FW UPDATE TOOL MESSAGES

FW Update Tool Messages: Information

Message for USB update
Messages
USB Upload : End of data
USB Upload : FAIL
M156/M157/M176/M177
Comment
Sent F/W file to MFP
successfully.
(Transmission Time: <30 sec)
Cannot open USB printer
driver while F/W file is
transmitted.
F/W file transmission cannot
be completed.
(Transmission will be canceled
if timeout.)
5-24
Action
Please reboot MFP after
panel shows reboot
message.
Check USB cable
connection.
Check whether the USB
Print Driver is available.
Check whether the MFP is
available.
Check USB cable
connection.
Check whether the USB
Print Driver is available.
Check whether the MFP is
available.
SM