Data Communication Problems; Memory Stick Problems; Bluetooth Problems; Revision History - Sony Ericsson P910a Troubleshooting Manual, Mechanical

15 Data Communication Problems

•
Perform sections 1.1 (Liquid Damage) and 1.2 (Flashing) before proceeding
Troubleshooting Steps
1. If there are communication issues when a device is
connected to the system connector, check whether
the system connector is damaged, dirty, or oxidized.
If the system connector is dirty or oxidized, clean it.
If the system connector is damaged, send the unit to
a location approved to perform electrical repairs.
NOTE!
2. For communication problems with Bluetooth and
infrared, refer to the specific sections that address
these items.
•
Refer to section 1.3 (Unrepairable at the Mechanical Level)

16 Memory Stick Problems

•
Perform sections 1.1 (Liquid Damage) and 1.2 (Flashing) before proceeding
If a problem with the memory stick is determined to be with the memory stick connector, the unit
must be sent to a location approved to perform electrical repairs.

17 Bluetooth Problems

•
Perform sections 1.1 (Liquid Damage) and 1.2 (Flashing) before proceeding
If a problem with Bluetooth is detected, the unit must be sent to a location approved to perform
electrical repairs.

18 Revision History

Rev.
A
4/000 21-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Be aware that the device that was connected
could be the cause of the problem.
Date Changes / Comments
2004-08-13 Initial Release
Trouble Shooting Guide, Mechanical
22(22)