Charging/Capacity Problems - Sony Ericsson P910a Troubleshooting Manual, Mechanical

10 Charging/Capacity Problems

•
Perform sections 1.1 (Liquid Damage) and 1.2 (Flashing) before proceeding
Troubleshooting Steps
NOTE!
1. If the phone will not charge and the customer's
battery is present with the phone, check that the
contact pads on the battery are not damaged, dirty, or
oxidized. Clean the contact pads or replace the
battery as necessary.
2. Also, check whether the phone's battery connector is
damaged, dirty, or oxidized. If the battery connector
is dirty or oxidized, clean it. If damaged, send the
unit to a location approved to perform electrical
repairs.
3. Check whether the system connector is damaged,
dirty, or oxidized. If the system connector is dirty or
oxidized, clean it. If the system connector is
damaged, send the unit to a location approved to
perform electrical repairs.
•
Refer to section 1.3 (Unrepairable at the Mechanical Level)
4/000 21-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Some features will noticeably reduce the
standby time of this product if they are
turned on. Some examples are the back
light (when on all the time), Bluetooth, and
infrared.
Trouble Shooting Guide, Mechanical
17(22)