Invacare Ultra-Light Neo Manual page 10

- Method for the mini-adaptor plate:
Slacken the mini-adaptor plate (10mm open-ended spanner, steadying
with 4mm Allen key). Fit the plate to the desired height and re-tighten.
Horizontal adjustment
This adjustment influences the wheelchair's ability to tip: The further
you place the rear wheel to the front of the wheelchair, the less stable
the wheelchair will become.
- Method for the vertical adaptor plate:
Slacken the adaptor plate (10mm open-ended spanner, steadying with
4mm Allen key). Fit the plate to the desired position and re-tighten.
- Method for the horizontal adaptor plate:
Slacken the adaptor sleeve on the adaptor plate (22 mm open-ended
spanner, steadying with 22mm open-ended spanner). Insert the adaptor
sleeve in the desired hole of the adaptor plate and re-tighten.
- Method for the mini-adaptor plate:
The mini adaptor plate is used as a rear wheel
extension when positioned backwards. Slacken
the adaptor plate (10mm open-ended spanner,
4mm Allen key). Fit the plate to the desired
position, either facing to the front or facing to the
back of the wheelchair and re-tighten.
Front wheel adjustment
Height adjustment
If your wheelchair model is equipped with a 5" or 8" front wheel fork, you
can position the front wheel in one of the other axle seats available on the
fork. Slacken the front wheel axle (13mm open-ended spanner, steadying
with 13mm open-ended spanner) and place the castor to the desired
height.
ULTRA-LIGHT NEO
The clamping lug can be fitted in two ways:
- Pointing upwards=low front floor to seat
height
- Pointing downwards = high front floor to seat
height (standard).
Adjustment
Slacken the threaded joint of the bearing block
(5mm Allen key). The two other clamping
piece screws must also be slackened. By
fitting at a 180° you will achieve the new front
floor to seat height. When fitting the clamping
pieces, ensure (before tightening the threaded
joint) that the clamping pieces are at a right
angle to the ground.
Tête de fourche
orientée vers le haut
Tête de fourche Tête de fourche
orientée vers le haut orientée vers le bas
GB
Tête de fourche
orientée vers le ba
33