Call Transfer And Intercom Between Two Handsets; Call Transfer And Conference Call During An External Call; Internal Call (Intercom); Base Telephone Operation - Topcom BUTLER 2920 User Manual

Topcom Butler 2920
• Enter the pin code (0000). If the pin is wrong, the handset will go back to standby.
• Enter the handset number (1-5) you want to remove
• The unit will go back to standby is the removal is successfully. If not, it will ask again to enter the handset number
Remark: You can only remove existing handsets and others then the one you are using
8. CALL TRANSFER AND INTERCOM BETWEEN TWO
HANDSETS

8.1 CALL TRANSFER AND CONFERENCE CALL DURING AN EXTERNAL CALL

• During an external call, press the INT key followed by the number (1 - 5) of the other handset.
• The other handset will start to ring:
- When the other handset takes the line you can talk internally.
If you hang up, the external line will be connected with the other handset.
If you press and hold the INT key for 3 seconds you can talk with the 2nd handset and external line at the same
time (conference call)
- Or press the INT key again to return to the external call.
• Press the Line button

8.2 INTERNAL CALL (INTERCOM)

• In standby press the INT key followed by the number (1-5) of the other handset.
• The other handset will start to ring. You can stop the ringing by pressing the Line button
• If the other handset answers the call by pressing the Line button
• Press the Line button

9. BASE TELEPHONE OPERATION

You can also make a telephone call by using the base station handsfree speakerphone.

9.1 MAKING A CALL

• Press the Handsfree base dialling key
• Press the numeric keys on the base to form a telephone number
• Press again the Handsfree base dialling key to end the telephone conversation

9.2 ADJUSTING THE SPEAKER VOLUME

Press the '+' or '-' key
too loud there is the possibility that the speaker starts to oscillate (flute tone). To avoid this, please lower the speaker
volume.
Caution: The handsfree communication is half duplex which means that if the person on the other side of
the line starts to speak, the microphone is muted, so the person can't hear you at that time. Please try to
avoid speaking to each other at the same time.

9.3 SETTING THE DIAL MODE FOR THE BASE

You can set the base dialling mode in Pulse(P) or Tone/DTMF(T) by the switch at the bottom of the base.
Caution: The base dialling mode is independent from the handset.
Topcom Butler 2920
PIN 1234
to end the call.
to end the call.
to take the line
during base handsfree conversation to adjust the speaker volume. If the speaker volume is
H5-
you can talk internally.
.
13