Figure 51. Placing the system processor module at an angle on the top cover of the packaging
10. Press the top of the pen to release the system processor module onto the cover.
Figure 52. Releasing the pen
Replacing a system processor module in the 7063-CR1
Learn how to replace a system processor module in the IBM 7063-CR1 Hardware Management Console
system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Inspect the system processor socket area and remove any dust or debris (use a can of compressed air).
50
Power Systems: Servicing the 7063-CR1 Hardware Management Console system