IBM Power Systems 7063-CR1 Service Manual page 52

7. Inspect the system processor socket area and remove any dust or debris (use a can of compressed
air).
8. Lower the vacuum pen tool onto the system processor module to install. Fully press the top of the
pen (A) and hold the pen in the center of the system processor module as shown in Figure 36.
Release the top of the pen to fasten the pen onto the system processor module.
Note: To prevent the system processor module from falling, do not press the tip while holding the
pen and the system processor module. Minimize the time and distance that you have the pen
holding the system processor module, in case the vacuum seal releases early.
Figure 36. Lowering the removal tool onto the system processor module
9. Holding the pen, lift the pen and system processor module from the old system backplane socket to
transfer it to the new system backplane socket.
10. Install the system processor module:
a. Lower the pen and system processor module onto the socket as shown in Figure 37 on page 37.
Align the beveled corner of the system processor module with the beveled corner on the system
processor socket. Use care to lower the tool evenly without tilting the system processor module.
Note: Do not attempt to slide the tool and the system processor module in any direction while
the system processor module is touching the system processor socket.
36
Power Systems: Servicing the 7063-CR1 Hardware Management Console system