Log Placement - Napoleon Knightsbridge VF Series Installation And Operation Manual

fi nishing
EN
5.3

log placement

!
WARNING
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since appli-
ance may not function properly and delayed ignition may occur.
• Logs are fragile and should be handled with care.
• Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits, and delayed ignition.
TM
PHAZER logs glow when exposed to direct fl ame and provide a unique and realistic glowing effect. Use only
certifi ed PHAZER TM
A.
Place log #1 onto the burner, centering it onto the
burner tray and pushing it as close to the rear wall
of the fi rebox as possible. Move logs #2 and #3
into position, lining up the studs located on the
burner with the holes on the bottom of the logs. Sit
the notch at the bottom of log #4 against the left
outermost grate post and position the top of the
log into the pocket provided on the rear log (#1).
B.
The notch in log #5 should be pressed down onto
the skewering pin located at the end of the grate
as shown to prevent it from rocking.
C.
Position the notch located in log #6 against the
grate post and rest it within the notch in log #4.
D.
Place the bottom of log #7 against the right
outermost grate post and the top into the pocket
provided on the center log (#6). Bend up the tab in
the log support to cradle log #7. Tear the glowing
embers into pieces and place onto the front of the
burner. Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed
edges of the fi bre hairs will glow when exposed to
direct fl ame; however care should be taken to not
block the burner ports. Blocked ports can cause
an incorrect fl ame pattern, carbon deposits and
delayed ignition.
Replacement loose material must be purchased from the
original room appliance manufacturer. Application of excess
loose material may adversely affect the performance of the
appliance.
Log colours may vary. During the initial use of the appli-
ance, the colours will become more uniform as colour pig-
ments burn in during the heat activated curing process.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
14
W415-1966 / 07.08.19
logs available from your local authorized dealer / distributor.
1
4
3
2
5
6
7