Siemens SIMATIC NET TeleControl S7-1200 CP 1243-1 Operating Instructions Manual page 105

You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
c(UL)us
Applied standards:
● Underwriters Laboratories, Inc.: UL 61010-1 (Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements)
● IEC/UL 61010-2-201 (Safety requirements for electrical equipment for measurement,
control and laboratory use. Particular requirements for control equipment)
● Canadian Standards Association: CSA C22.2 No. 142 (Process Control Equipment)
Report / UL file: E85972 (NRAQ.E85972)
cULus Hazardous (Classified) Locations
Underwriters Laboratories, Inc.: cULus IND. CONT. EQ. FOR HAZ. LOC.
Applied standards:
● ANSI ISA 12.12.01
● CSA C22.2 No. 213-M1987
APPROVED for Use in:
● Cl. 1, Div. 2, GP. A, B, C, D T4A; Ta = -20 °C...60 °C
● Cl. 1, Zone 2, GP. IIC T4; Ta = -20 °C...60 °C
Report / UL file: E223122 (NRAG.E223122)
The conditions must be met for the safe deployment of the CP according to the section
Notices regarding use in hazardous areas according to UL HazLoc (Page 29).
FM
Factory Mutual Approval Standard Class Number 3600, 3611, 3810, ANSI/ISA-61010-1
Equipment rating:
Class I, Division 2, Group A, B, C, D, Temperature Class T4A, Ta = 60 °C
Class I, Zone 2, Group IIC, Temperature Class T4, Ta = 60 °C
Certificate of Compliance: 3049779 and 3049925
The conditions must be met for the safe deployment of the CP according to the section
Notices on use in hazardous areas according to FM (Page 29).
Australia - RCM
The CP meets the requirements of the AS/NZS 2064 standards (Class A).
CP 1243-1
Operating Instructions, 12/2016, C79000-G8976-C365-02
Approvals
105