IBM AS/400e Manual page 72

__ 14. Refer to Figure 41 and support the bottom of the removable media device
__ 15. Select option 2 (Install device for the action to be performed).
__ 16. Set the time delay for one minute.
__ 17. When the light starts blinking, slide the removable media device in until it
Figure 41. Installing removable media
__ 18. The green light will stop blinking and remain on solid when you properly
__ 19. Return to the console and wait until the Concurrent Maintenance Results
__ 20. When the Hardware Service Manager display appears, press F6 to print the
__ 21. Install the front cover for the expansion unit.
__ 22. Press F12 twice and press the Enter key to return to the AS/400 Main
The installation of the removable media device is complete.
60
Setting Up Your 5065 or 5066 Expansion Unit V4R5
assembly as you slide it half way into the next available position. Do not
push it any further.
01
Press the Enter key.
Note: Watch the light on the right side of the removable media devices. If
the light comes on and begins to blink rapidly, you have nine
seconds to slide the removable media device into place.
seats properly. Push both blue handles in at the same time to lock the
removable media device into place.
installed the removable media device.
display appears.
Press the Enter key.
configuration list if you have a printer. You or a service representative may
refer to the configuration list in the future.
menu.