IBM AS/400e Manual page 26

__ 8. Remove the SPCN cable (the SPCN cable between system unit and unit X)
__ 9. Use the latch that is shown at A to open the back cover on your
__ 10. If needed, use latch that is shown at B to remove the back cover.
Figure 16. Opening or removing 5065 Expansion Unit back cover
__ 11. Refer to Figure 17 on page 15 and install the optical cable that you removed
__ 12. Plug the SPCN cable that you removed from unit X into the SPCN
__ 13. Tighten the thumbscrews.
14
Setting Up Your 5065 or 5066 Expansion Unit V4R5
from connector J15 on unit X. Do not disconnect the cable from your
system unit.
expansion unit.
from unit X into the optical connector on your 5065 that is labeled 0. The
optical cable should now run between your system unit and your 5065.
connector J15 on your 5065. The cable should now run between your
system unit and your 5065.