Setting An Ipv4 Address - Canon imageRUNNER ADVANCE C5560i III User Manual

Setting an IPv4 Address

There are two methods to set an IPv4 address: allocating automatically using DHCP and entering manually. Select
either of the two according to your environment. Conduct a connection test as necessary.
Setting an IPv4 Address(P. 37)
Conducting a Connection Test for an IPv4 Address(P. 38)
Setting an IPv4 Address
1
Press .
2
Press <Preferences>
3
Press <Use IPv4>
4
Press <IP Address Settings> and set an IP address.
● You can set both automatic allocation and manual allocation. If you set both and set <Release Address Last
Acquired from DHCP Server When Address Cannot Be Acquired> to <Off>, the manually entered IP address is
used when automatic IP address retrieval fails.
Automatic allocation using DHCP
Press <DHCP> or <Auto IP>. Select one of them according to your network environment. If you select both
<DHCP> and <Auto IP>, automatic allocation using DHCP takes priority.
● If you press <Auto IP>, the available IP address is automatically searched in the network (LAN) and the
value for each item is allocated. This function allocates the IP address without using a DHCP server.
However, communication outside of the router range is not available.
● In an environment where both <DHCP> and <Auto IP> cannot be used, if either of the two is selected,
useless communication occurs because the machine tries to check if the service is provided on the
network.
Setting by manual entry
1
Confirm that both <DHCP> and <Auto IP> are canceled.
● If either of the two is selected, press the button to cancel.
2
Enter the IP address, the subnet mask, and the gateway address.
● Press the button corresponding to each and enter values.
5
Press <OK>.
Setting Up
<Network> <TCP/IP Settings>
<On> <OK> to enable IPv4 settings.
37
<IPv4 Settings>.
4XR3-00L