Manual instruction | Gasoline grass trimmer - Gasoline brushcutter
difficult to start).
6.
handle (14) until engine starts.
7.
to warm up for a few minutes
before using.
starting warm engine
•
If the fuel tank (11) was not run dry, pull the
starter (14) one to three times and should start.
Do not use choke
•
If the fuel tank (11) was run dry, after refilling
repeat steps 3 thru 7 in. "Starting cold engine"
chapter.
Stopping the engine
•
Move the ignition switch (6) to "STOP" position.
Maintenance and care
Air filter
1.
Accumulated dust in the air filter will reduce
engine efficiency. Increase fuel consumption and
allow abrasive particles to pass into the engine.
Remove the air filter as often as necessary to
maintain a clean condition.
2.
Light surface dust
can readily be removed
by tapping the filter.
Heavy deposits should
be washed out in
suitable solvent.
3.
Remove the filter
cover (12) by loosening
the air filter cover knob (T).
Adjusting the carburator
Do not adjust the carburetor unless necessary. If
you have trouble with the Carburetor, please call
IVT dealer. Improper adjustment may cause engine
damage And void warranty.
Fuel Filter
1.
Fuel tank is fitted with a filter. the filter is situated
at the free end of the fuel pipe and can be picked
out through the fuel port with a piece of hooked
wire.
2.
Check the fuel filter periodically. Do not allow
dust to enter into the fuel tank. Clogged the
filter will cause difficulty in starting engine or
abnormalities in starting engine or abnormalities in
engine performance.
EN
3.
Pull
the
starter
4.
cleaned by rinsing the tank out with gasoline.
Allow the engine
Check spark plug
Do not attempt to remove the plug from a hot
engine in order to avoid possible damage to the
threads.
Troubleshooting
Generals
1.
heavy oily deposits.
2.
is worn rounded at the end.
3.
4.
135in.lb)
when the engine will not start
•
the fuel tank.
•
there is water in it, replace fuel.
•
there, clean fuel filter
•
not, replace the spark plug. If still not spark take the
brush cutter to an authorized IVT dealer.
T
To check:
1.
around the spark plug.
2.
in the plug cap.
3.
head.
4.
gap.
Be sure there is no spilled fuel around the spark
plug. Spilled fuel may ignite.
when the power tool has a low output
•
smoke is thin ► check and adjust the carburetor
•
piston ring
when the engine is running unstable
10
When the filter is dirty, replace the filter.
When the inside of the fuel tank is dirty, it can be
Clean or replace the plug if fouled with
Replace the plug if the center electrode
Spark gap 0.6-0.7mm (.023".028")
Fastening torque = 145-155kg.cm (125-
Check if there is fuel in the tank
Check the fuel in the tank
Check if there is a fuel filter obstruction
Check if there is a spark from the spark plug
Remove the spark plug cap and clean any dirt off
Remove the spark plug and install the spark plug
Set the plug side electrode on the cylinder
Crank the engine. sparks should jump across the
if there is a flameout when speedup and the
if there is compression shortage
0.6-0.7 mm
► If not, refill
► If it is too dirty or
► If
► If
► replace the