Setup Instructions - Central Pneumatic 93657 Assembly And Operating Instructions Manual

1/8 hp oil-less airbrush compressor with regulator

Hide thumbs Also See for 93657:

Owner's manual & safety instructions (16 pages)

Owner's manual & safety instructions (12 pages)

Table Of Contents

Table of Contents

When unpacking, check to make sure all the parts shown on the Parts List on page 11

are included. If any parts are missing or broken, please call Harbor Freight Tools at the

number shown on the cover of this manual as soon as possible.

CAUTION! Always make sure the Power Switch (34) of the Air Compressor is

in its "OFF" position and the unit is unplugged from its electrical outlet prior to per-

forming any service, maintenance, or cleaning of the Compressor.

Before operating, make sure the Air Compressor is set up in a well-ventilated area,

on a flat, level, solid surface well away from any flammable objects, such as drapes.

Never paint in an area without proper ventilation, or near possible ignition sources.

To Start The Compressor:

Insert the Power Cord Plug (35) into the nearest 120 volt, grounded, electrical out-

let. (See Figure A.)

Connect an Air Brush (not included) to the Air Hose (42) of the Compressor. Use

Hose Adapter (44) if needed.

Turn the Power Switch (34) to its "ON" position. (See Figure A.)

FIGURE A

Note: This Compressor is designed for

use with air brushes; never attempt to

operate this compressor with any other

type of painting equipment.

SKU 93657

For technical questions, please call 1-800-444-3353.

UNPACKING