Table of Contents
Advertisement
2.
If using the Laser Level with the Tripod (3), thread the Tripod Stud located on the
Tripod Neck into the bottom of the Laser Level. The Tripod swivels 360 degree.
Position the Tripod on a flat, level, dry ground surface. Extend the Legs of the
Tripod and lock the Legs in place. Level the Tripod Neck (4), using the Level Vial
(4) located on the Tripod Head. Then, lock the Tripod Neck in position with the
Thumb Screw (6). (See Figure B.)
TRIPOD (3)
FIGURE B
3.
The Laser Level may also be installed on a wall surface without the Tripod (3).
To do so, use the Wall Bracket (7) to secure the Laser Level to the wall. Use the
wall bracket as a template. Mark drill holes and always check before drilling to
make sure there are no hidden electrical wires or cables in the drilling path.
Secure the Laser Level to the wall surface using screws and plastic anchors (not
included). (See Figure A.)
4.
Level the Laser, using a Leveling Knob (8) located on each side of the Laser and
the two Level Vials (9) located at the top of the Laser. (See Figure C.)
RIGHT SIDE VIEW
SKU 92801
For technical questions, please call 1-800-444-3353.
LEFT SIDE VIEW
LEVEL
VIALS (9)
ROTATION
SPEED
CONTROL
(10)
LEVELING
KNOB
(8)
FIGURE C
TRIPOD NECK
(4)
LEVEL VIAL
(4)
THUMB SCREW
(6)
Page 7
Hide quick links:
Advertisement
Table of Contents
