Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-4E1G. This chapter contains the following sections:
•
•
•
•
•
•
•
•
Required Tools and Equipment
You need the following parts and tools to install the PA-4E1G. If you need additional equipment, contact
a service representative for ordering information.
•
•
Note
•
•
•
•
•
•
OL-3065-05
Required Tools and Equipment, page 2-1
Minimum Software and Hardware Requirements, page 2-2
Checking Hardware and Software Compatibility, page 2-3
Safety Guidelines, page 2-3
FCC Class A Compliance, page 2-10
Telecommunications Authority of Singapore, page 2-11
BABT Compliance, page 2-11
Other Safety and Compliance Approvals, page 2-11
PA-4E1G-120 (for balanced operation) or PA-4E1G-75 (for unbalanced operation)
VIP2, VIP4, or VIP6-80 (for installation in Cisco 7000 series or Cisco 7500 series chassis only). For
information about the specific VIP models that support the PA-4E1G, see the
and Hardware Requirements" section on page
Cisco 7000 series and Cisco 7500 series routers require the VIP2-15 at minimum.
Cisco 7304 PCI Port Adapter Carrier Card (for installation in a Cisco 7304 router)
75-ohm unbalanced or 120-ohm balanced, 15-pin serial cables with 15-pin, D-shell (DB-15)
terminations at the port adapter end
Number 1 Phillips and a 3/16-inch flat-blade screwdriver
Number 2 Phillips screwdriver
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares
Antistatic mat
C H A P T E R
2-2.
PA-4E1G Serial Port Adapter Installation and Configuration
2
"Minimum Software
2-1
Advertisement
Table of Contents
