Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
Cisco PA-5EFL port adapter. This chapter contains the following sections:
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install a port adapter. If you need additional equipment, contact
a service representative for ordering information.
•
•
•
•
•
•
•
•
OL-3495-02
Required Tools and Equipment, page 2-1
Software and Hardware Requirements, page 2-2
Safety Guidelines, page 2-3
FCC Class A Compliance, page 2-8
PA-5EFL(=)
VIP2 (for installation in the Cisco 7000 series or Cisco 7500 series chassis only). For information
about the specific VIP models that support the PA-5EFL port adapter, see the
Hardware Requirements" section on page
Cables appropriate for the port adapter interfaces (ST-type optical-fiber cables are not available from
Cisco Systems; they are available from outside commercial cable vendors.)
Number 1 Phillips and a 3/16-inch, flat-blade screwdriver (for VIP2 installation only).
Number 2 Phillips screwdriver.
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.
Antistatic mat.
Antistatic container.
2-2.
PA-5EFL Ethernet 10Base-FL Port Adapter Installation and Configuration
C H A P T E R
"Software and
2
2-1
Advertisement
Table of Contents
