Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-POS-2OC3. This chapter contains the following sections:
•
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install a PA-POS-2OC3. If you need additional equipment,
contact a service representative for ordering information.
•
•
•
•
•
•
•
•
•
•
OL-3028-06
Required Tools and Equipment, page 2-1
Software and Hardware Requirements, page 2-2
Checking Hardware and Software Compatibility, page 2-4
Safety Guidelines, page 2-4
FCC Class A Compliance, page 2-12
PA-POS-2OC3
Cisco 7200 VXR routers Port Adapter Jacket Card for installation of a port adapter in the I/O
controller slot (requires an NPE-G1)
Cisco 7304 PCI port adapter carrier card for installation in a Cisco 7304 router
VIP motherboard (40, 60, 80) for installation in Cisco 7500 series modules
FlexWAN module for installation in Cisco 7600 series modules
One LC-type duplex or two LC-type simplex, multimode, or single-mode optical fiber cables per
port to connect the interface with the network. (Single-mode and multimode optical fiber cables for
the PA-POS-2OC3 are not available from Cisco Systems but are available from commercial cable
vendors. For information about optical fiber cables, see the
section on page 1-4
and the
Number 1 Phillips screwdriver
Number 2 Phillips screwdriver
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares
Antistatic mat
PA-POS-2OC3 Two-Port Packet-over-SONET Port Adapter Installation and Configuration
C H A P T E R
"Cables and Connectors" section on page
2
"OC-3 Optical Fiber Specifications"
1-6.)
2-1
Advertisement
Table of Contents
