Using Your Mask - ResMed Quattro Air User Manual


As with all masks, some rebreathing may occur at low CPAP
pressures.

Refer to your CPAP or bilevel device manual for details on
settings and operational information.

Remove all packaging before using the mask.

Using your mask

When using your mask with ResMed CPAP or bilevel devices that
have mask setting options, refer to the Technical specifications
section in this user guide for mask selection options.
For a full list of compatible devices for this mask, see the
Mask/Device Compatibility List on www.resmed.com on the
Products page under Service & Support. If you do not have internet
access, please contact your ResMed representative.
Use a standard conical connector if pressure readings and/or
supplemental oxygen are required.
Fitting
The fitting illustrations in this guide show the sequence for obtaining
the best fit and comfort when using your mask. A diagram showing
the names of parts can be found in the Mask Components diagram
near the beginning of this guide.
Fitting steps
1. Remove the elbow from the mask by pressing the side buttons
and pulling the elbow away.
2. With both lower headgear straps released, hold the mask against
your face and pull the headgear over your head. Ensure that the
label on the back of the headgear faces outwards when the
headgear is put on.
3. Undo the fastening tabs on the upper headgear straps. Pull the
straps evenly until the mask is stable and positioned as shown.
Reattach the fastening tabs.
4. Bring the lower straps below your ears and loop the headgear
into the lower hooks on the frame.
English
3