Table of Contents
Advertisement
•
Press one of the options to deactivate the
energy saving status.
DAILY USE - DRYING ONLY
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
DRYING SETTING
WARNING! Make sure that the
water tap is open.
1. Turn the programme knob to
appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the programme
applicable for the items to dry. The display
shows the drying indicator
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
DRYING AT AUTOMATIC LEVELS
The laundry can be dried at pre-defined levels of
dryness:
1. Press
again and again until the display
shows one of the dryness level indicator:
•
: IRON DRY level indicator for cotton
items
•
: CUPBOARD DRY level indicator for
cotton and synthetic items
•
: EXTRA DRY level indicator for cotton
items
The display shows a time value, calculated on the
default load size. If the amount of your laundry is
more or less than the default size, the appliance
adjusts automatically the time value during the
cycle.
2. Press
to start the programme.
16
The display shows the door locked indicator
The drying indicator
TIMED DRYING
The laundry can also be dried with a manual timed
drying:
1. Press
to activate the
.
2. Press
END OF THE DRYING PROGRAMME
The appliance stops automatically.
•
•
•
•
If you set a programme or an option
that ends with water in the drum, the
energy saving status function doesn't
activate to remind you to drain the
water.
starts to flash.
You cannot set all dryness levels for
any type of laundry.
again and again to set the time value
(see the «Programmes for timed drying» table).
•
The display shows 10 minutes. Each time
you press this touchpad the time value
increases by 5 minutes.
•
The display shows the set time value: for
example –
.
•
After some seconds the display shows a
new time value:
calculates also the duration of the anti-
crease and the cooling phases.
to start the programme.
•
The display shows regularly a new time
value.
•
The drying indicator
•
The display shows the door locked
indicator
.
If you set only 10 minutes of drying,
the appliance performs only a cooling
phase.
If the laundry is not sufficient dry, set
again a short drying time.
The acoustic signals operate (if they are active).
In the display
comes on.
The indicator
goes off.
The last minutes of the drying cycle the
appliance performs a cooling and anti-crease
phase. The door is still locked.
.
. The appliance
starts to flash.
Advertisement
Table of Contents
