Table of Contents
Advertisement
When the door locked
you can open the door.
1. Turn the programme knob to
the appliance.
After some minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
DAILY USE - WASHING & DRYING
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
NON-STOP PROGRAMME
1. Turn the programme knob to
appliance.
2. Load the laundry one item at a time.
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
3. Put the detergent and the additives in the
appropriate compartment.
4. Turn the programme dial to the washing
programme.
The display shows the indicators of the different
washing phases.
5. Set the available options.
WASHING & AUTOMATIC DRYING
1. Press
again and again until the display
shows one of the dryness level indicator:
•
: IRON DRY level indicator for cotton
items
•
: CUPBOARD DRY level indicator for
cotton and synthetic items
•
: EXTRA DRY level indicator for cotton
items
The display shows the indicator
on the display is the duration of the washing +
drying cycles, calculated on a default load size.
goes off in the display,
to deactivate
to activate the
. The time value
2. Remove the laundry from the appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
To have a good drying the appliance
does not let you set a too low spin
speed for the items to be washed and
dried.
2. Press
to start the programme.
In the display the indicator of the set dryness level
stays on.
The door locked indicator
The display shows regularly a new time value.
The last minutes of the drying cycle
the appliance performs the anti-crease
and the cooling phases.
WASHING & TIMED DRYING
To have a good drying the appliance does not let
you set a too low spin speed for the items to be
washed and dried.
1. Press
to set the drying time value. The
display shows 10 minutes.
The indicator
comes on in the display. The
display shows the set drying value time. for
example:
. After some seconds the display
shows the final time value
duration of the washing and drying cycles (washing
+ drying + anti-crease + cooling phases).
If you set only 10 minutes of drying
after washing, the appliance calculates
also the duration of the anti-crease
and the cooling phases.
2. Press
to start the programme.
In the display the indicator
is locked. The display shows regularly a new time
value.
END OF THE PROGRAMME
The appliance stops automatically. The acoustic
signals operate (if they are active).
goes on.
, that is the total
comes on. The door
17
Advertisement
Table of Contents
