Daily Use - Drying Only - Zanussi ZNT816PCWA User Manual

the Modo - Lavar and Modo - Secar
buttons are on. The indicator
on the display.
12.2 Washing and Drying -
Automatic levels
1. Tap on the Auto Dry button repeatedly
until the display shows the required
dryness level. The indicators in the
display illuminate accordingly:
a. Iron dry: for cotton items;
b. Cupboard dry: for cotton and
synthetic items;
c. Extra dry: for cotton items.
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load size.
To have a good drying by using less
energy and in a shorter time, the
appliance does not let you set a too low
spin speed for the items to be washed
and dried.
2. Touch button Inicio/Pausa
programme. The AutoAdjust estimation
starts.
In the display the door locked
comes on.
The display also shows the remaining
programme time.
12.3 Washing and Timed Drying
1. Tap on the Tiempo/Tempo Sec. button
repeatedly to set the desired time value
(see the "Timed drying" table in the
"Programmes" chapter). The drying level

13. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
This appliance is an automatic washer
dryer.
indicator
appears comes on.
Each time you tap on this button the time
value increases by 5 minutes. The display
shows the set new time value.
2. Touch the Inicio/Pausa
the programme. The AutoAdjust
estimation starts.
In the display the door locked
comes on.
The display also shows the remaining
programme time.
12.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they are
active).
• In the display
• The indicator of the Inicio/Pausa
button goes off. The door locked
indicator goes off and the door unlocks.
• Press the On/Off button for some seconds
to deactivate the appliance.
to start the
After some minutes from the end of
the programme, the energy saving
indicator
function deactivates the appliance
automatically.
1. Remove the laundry from the appliance.
2. Make sure that the drum is empty.
After drying phase, clean the drum, the
seal and the inside of the door with a wet
cloth.
13.1 Preparation to drying
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to dry.
The appliance defaults to the washing
goes off and the indicator
button to start
indicator
comes on.
ENGLISH 35